Lamp Module Plug In Switching Unit

Summary:

Enables the automated switching/remote control/dimming of plug in lamps. Plugs into any 13 Amp socket and received X10 signal over the mains wiring from any X10 controller such as the HR10 Remote Control, MT12 Mini Timer or the CM12U Computer Interface.

• Plug and Play installs in seconds
• Allows on/off and dim/bright control

These plug-in modules will allow you to remotely control plug-in table lamps, and other plug-in type lights. There's no re-wiring to do. Simply set the X10 address, un-plug the lamp, plug the lamp into the module, and plugs the module into your mains socket. You instantly have X10 control of the device.

The Lamp Module has a minimum rating of 60W, and a maximum rating of 300W. The Lamp Module is dimmable, and should only ever be used to control incandescent or 12 V halogen lamps.

Use in conjunction with an X10 transmitters such as the HR10 Remote Control, MT12 Mini Timer or the CM12U Computer Interface.

Features:

• Perfect for switching lights and lamps on/off remotely
• Great for dimming, energy saving and hard of reach places

Contents:

• LM12 Lamp Unit
• Full operating and installation instructions

Ideal for:

• Lamps, and lights

Technical Data:  

Supply voltage: 230 V +/-10% 50 Hz

Supply current: 20 mA capacitive

Making capacity: 60 to 300 W (incandescent, and 12 V halogen lamps only)

Regulating time: 4,4 sec +/- 0.2sec from fully on to off

EMC emission: According to EN 50081-1 EMC immunity: According to EN 50082-1 Electrical safety: According to EN 60950 and EN 60065 Signal sensitivity: 15 mVpp min 50 mVpp max at 120 kHz Input impedance: 55 W (L - N) at 120 kHz

Ambient temperature: - 10 degrees C to + 50 degrees C (operation) - 20 degrees C to + 70 degrees C (storage)

Dimensions: 52 x 122 x 33 mm (width x height x depth without plug)

Installation:

Setup is easy and fast and takes hardly any time.